DD-79 Deduster


The Go Fast DD79 Deduster is the solution to sawdust left on boards. Material can be fed by hand or from an inline process into the machine's hopper. An adjustable gate allows the rubber feed belt to pull the bottom board forward to the feed wheel and through the top and bottom rotating brushes. The easily adjustable height allows you to minimize change over down time.


  • THE DIFFERENCE: There are several features that set the Go Fast Deduster apart from the rest, and it all starts with the brush! Our side sweeping disc brushes sweep sideways, providing cleaner boards than traditional drum brushes. They also do not require an air collection.
  • BOARD KNOCKER: Our famous board knocker system helps meter the boards through the machine one at a time. It breaks frozen and sticky boards apart and prevents 99% of jams!


  • Length: 79"
  • Width: 34"
  • Height: 58"
  • Feed Belt Height: 27" - 36"
  • Exit Pinch Roller Height: 34"

  • Board Width: 2" - 6 1/4"
  • Board Thickness: 3/8 - 2.5"
  • Board Length: 18" Minimum

  • 10 Gal Reservoir Capacity
  • Self-Contained 5 GPM System with Variable 0 - 700 Feet Per Minute Feed Speed

  • 5HP Electric Motor 208/230/480/3/60 TEFC
  • Completely Pre-Wired Motor Starter with Start/Stop Buttons and Circuit Overload Protection

  • 5HP Single Phase
  • Infeed Rollers
  • Outfeed Belt
  • Sorting Table
  • Stacking Rack
  • Line Shaft: Available Without Power Set to Run Off Line Shaft

Copyright © Go Fast Manufacturing. All rights reserved.
Site Designed and Maintained by Lumbermen Online